Skip to main content

Official Journal of the Japan Wood Research Society

  • Original Article
  • Published:

Evaluation of the section modulus for tree-stem cross sections of irregular shape

Abstract

The effect of section modulus, as estimated for tree stems of irregular cross section with hollow trunks, on windthrow resistance is discussed. The sample trees were 12 aged poplar trees growing along the roadside in Sapporo. Binarized bitmap images of photographs of the crosscut surface of the sample tree stems were used to calculate numerical solutions for section moduli. The error for image resolution was simulated to less than 1% under the condition in which the image was divided into more than 400 pixels. The coefficient of variation in section modulus concerning six neutral axis directions in a horizontal plane was 11%–14%. The reduction in section modulus caused by decay or hollow trunk was 36%–56% of the full cross section. The effect of section modulus on critical wind velocity was found to be considerable. The critical wind velocity calculated for some of the sample trees was less than 40m/s, and these trees were considered to be in danger of bending failure of the stems.

References

  1. Hirata T (1953) Fundamental studies on the formation of cutting series (2) (in Japanese). Bull Tokyo Univ Forest 45:67–88

    Google Scholar 

  2. Fraser AI (1964) Wind tunnel and other related studies on coniferous trees and tree crops. Scot Forest 18:84–92

    Google Scholar 

  3. Leiser AT, Kemper JD (1973) Analysis of stress distribution in the sapling tree trunk. J Am Soc Hortic Sci 98:164–170

    Google Scholar 

  4. Mayhead GJ (1973) Some drag coefficients for British forest trees derived from wind tunnel studies. Agr Meteorol 12:123–130

    Article  Google Scholar 

  5. Johnson RC, Ramey GE, O’Hagan DS (1982) Wind induced forces on trees. J Fluid Eng 104:25–30

    Article  Google Scholar 

  6. Murakami S, Deguchi K, Takahashi T (1984) Shelter effects of trees as wind-breaks (in Japanese). Proceedings of Symposium on Wind Engineering, Tokyo, pp 129–136

  7. Koizumi A (1987) Studies on the estimation of the mechanical properties of standing trees by non-destructive bending test (in Japanese). Res Bull Coll Exp Forest Hokkaido Univ 44:1329–1415

    Google Scholar 

  8. Mattheck C (1998) Design in nature. Springer, Berlin, Heidelberg, New York, pp 1–276

    Book  Google Scholar 

  9. Rinn F, Schweingruber F-H, Schär E (1996) RESISTOGRAPH and X-ray density charts of wood comparative evaluation of drill resistance profiles and X-ray density charts of different wood species. Holzforschung 50:303–311

    Article  Google Scholar 

  10. Forest Products Laboratory (1987) Wood handbook. USDA Forest Service, Madison, pp 4.1–4.45

    Google Scholar 

  11. Cown DJ (1978) Comparison of the Pilodyn and Torsiometer methods for the rapid assessment of wood density in living trees. New Zeal J For Sci 8:384–391

    Google Scholar 

  12. Koizumi A, Ueda K (1987) Bending and torsional properties of logs (in Japanese). Res Bull Coll Exp Forest Hokkaido Univ 44:355–380

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Akio Koizumi.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Koizumi, A., Hirai, T. Evaluation of the section modulus for tree-stem cross sections of irregular shape. J Wood Sci 52, 213–219 (2006). https://doi.org/10.1007/s10086-005-0747-2

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10086-005-0747-2

Key words