Skip to main content
Journal of Wood Science

Official Journal of the Japan Wood Research Society

Fig. 7 | Journal of Wood Science

Fig. 7

From: Observation of machined surface and subsurface structure of hinoki (Chamaecyparis obtusa) produced in slow-speed orthogonal cutting using X-ray computed tomography

Fig. 7

CT images of the machined workpiece obtained by type II chip formation. Cutting angle was 70° and depth of cut was 0.3 mm. b a cross-sectional view (LT plane) of the workpiece. c, d, and e are cross-sectional views (RT plane) sliced at the dotted lines (c), (d), and (e) in b, respectively. White triangle in b and white arrow in e indicate the identical compressed area. White arrow in d indicates the accompanied tore area

Back to article page