Lumber type | n | ARW (mm) | AD (g/cm3) | MOE (GPa) | MOR (MPa) |
---|
Mean | SD | Mean | SD | Mean | SD | Mean | SD |
---|
I | 57 | 2.1a | 1.1 | 0.59a | 0.05 | 9.28a | 2.21 | 43.2a | 12.5 |
II | 104 | 2.0a | 1.1 | 0.60a | 0.04 | 10.15a | 2.36 | 52.3b | 21.4 |
III | 29 | 1.9a | 1.2 | 0.65b | 0.04 | 10.14a | 2.92 | 57.4b | 25.2 |
- The same letters (a and b) followed by mean values indicate no significance at the 5% level according to the Tukey–HSD test. The values of the MOE and MOR were adjusted to the values at 15% moisture content
- n number of lumber pieces, ARW annual ring width, AD air-dry density at testing, MOE modulus of elasticity, MOR modulus of rupture, SD standard deviation, I lumber including pith at an almost-center position in cross-section, II lumber obtained near the pith (sometimes including pith on the surface area of the lumber), III lumber obtained from outer part of the logs (without pith)